plcforum.uz.ua
http://plcforum.uz.ua/

Flying shear Mashin
http://plcforum.uz.ua/viewtopic.php?f=11&t=25856
Page 1 of 1

Author:  meysam123 [ Mon Feb 12, 2018 10:29 am ]
Post subject:  Flying shear Mashin

Hello ...
I'm researching about cross cutting systems(Flying Shear) of board and I want to do this project with PLC of Omron.I have two axis and two servomotor.
The boards are passing through the table and when they reach a certain length, the cutting machine begins to cut the board to a size. It is precisely the problem at this point of cutting and the decision time for the exact cutting.
How to calculate exact cutting time?If someone has an experience, please advise me.

Thanks a lot.

Page 1 of 1 All times are UTC + 3 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/