OMRON CP1H same program not working with same new PLC

CX-One, CX programmer, NTST, Syswin ....
Post Reply
kmarsus
Posts: 2
Joined: Fri Apr 25, 2014 3:14 pm

OMRON CP1H same program not working with same new PLC

Post by kmarsus » Mon Sep 07, 2015 6:33 am

Dear Omron experts,
I have omron PLC in my machine. Model: CP1H.
I have bought a new one for spare the PLC.
So, I have uploaded the software from old one through CX-One software and downloaded to new one.
Everything work fine with new PLC but one Solenoid valve is not working. I have tried many ways. I have again install old one it's fully working but when I install new one with same program only that particular solenoid valve is not working.
My both PLC are looking 100% same and the program also 100% same.
Can anyone suggest me where is the problem?

( I have attached my program here.
Program download link: https://www.dropbox.com/s/utff8db93roxv ... H.zip?dl=0
For program: line 52 and 53 output: 101.00 and 101.01
is responsible for the solenoid coil that's not working properly)

(tyou)

NowanH
Posts: 81
Joined: Wed Apr 30, 2014 6:16 pm

Re: OMRON CP1H same program not working with same new PLC

Post by NowanH » Sun Sep 13, 2015 11:46 am

Probably the output on the new PLC is faulty (I mean, at hardware level). You can write a short program to test all of the outputs.

Ouissam
Posts: 6
Joined: Sun Jun 07, 2020 10:39 pm

Re: OMRON CP1H same program not working with same new PLC

Post by Ouissam » Fri Sep 04, 2020 2:19 am

(gpost)

Post Reply