connect to CPM2A

CX-One, CX programmer, NTST, Syswin ....
Post Reply
kg200
Posts: 11
Joined: Wed Aug 13, 2008 4:22 pm

connect to CPM2A

Post by kg200 » Fri Aug 16, 2013 12:36 pm

hi everyone,
i have : usb-RS232 adapter and 2 connection tap (male & female), but i don't know how to wirring them to make connection between PC & PLC
anyone have the diagram?
tks alots

kg200
Posts: 11
Joined: Wed Aug 13, 2008 4:22 pm

Re: connect to CPM2A

Post by kg200 » Mon Aug 19, 2013 10:47 am

i found the answer in this 4r : http://www.plctalk.net/qanda/showthread.php?t=31757
with the diagram :
Image
i have tried (step by step as below), but not successful :
1.Creat PLC :
Image
2.COM setting:
Image
3.Work Online :
Image
4.
Image
5.
Image


and this my software version :
Image

(oo) plz help me!

vlad2006gr
Posts: 1032
Joined: Tue Nov 20, 2007 7:08 pm
Location: Belarus

Re: connect to CPM2A

Post by vlad2006gr » Mon Aug 19, 2013 8:19 pm

cable pinout:

PC (FEMALE)-------------------PLC(MALE)

2 --------------------------------2

3 --------------------------------3

4----- (PC)
----- I
6----- (PC)

5 --------------------------------9

----------------------------- ---- 4(PLC)
-----------------------------I
----------------------------- ---- 5(PLC)

Communications Switch is on.

Default communications settings :
Start bit: 1
Data bits: 7
Stop bits: 2
Parity: Even
Baud rate: 9,600 bps
Good luck!

Post Reply