[?]: CJ2H CPU65-EIP DeviceNet and Safety DeviceNet

CX-One, CX programmer, NTST, Syswin ....
Post Reply
pawelleg
Posts: 2
Joined: Wed Jul 21, 2010 5:31 pm

[?]: CJ2H CPU65-EIP DeviceNet and Safety DeviceNet

Post by pawelleg » Tue Jan 25, 2011 10:30 pm

Hello,

I/m looking for some advise on following question: how to configure DeviceNet network where on one bus standard I/O modules with safety controller and safety I/O modules will be connceted ?
Is it correct to make one configuration of DeviceNet in Safety Network Configurator or it have to be separated for standard DeviceNet (usind CX-Integrator) and Safety DeviceNet (using the Safety Network Configurator) :?:
btw, does anyone knows or is in possesion of the manual where two-digit display of CPU Unit is described?

will appriciate your support

kind regards
_pleg

pawelleg
Posts: 2
Joined: Wed Jul 21, 2010 5:31 pm

Re: [?]: CJ2H CPU65-EIP DeviceNet and Safety DeviceNet

Post by pawelleg » Wed Jan 26, 2011 7:27 am

pawelleg wrote:btw, does anyone knows or is in possesion of the manual where two-digit display of CPU Unit is described?
i have found display desription in that manual:
W465-E1-02 SYSMAC CS and CJ Series - CLICK!

http://support-omron.fr/pdf/W465-E1-02+ ... Manual.pdf
but still not sure about the first issue . . .

Post Reply