PLCforum.uz.ua

Hello,

I/m looking for some advise on following question: how to configure DeviceNet network where on one bus standard I/O modules with safety controller and safety I/O modules will be connceted ?
Is it correct to make one configuration of DeviceNet in Safety Network Configurator or it have to be separated for standard DeviceNet (usind CX-Integrator) and Safety DeviceNet (using the Safety Network Configurator)
btw, does anyone knows or is in possesion of the manual where two-digit display of CPU Unit is described?

will appriciate your support

kind regards
_pleg

pawelleg wrote:btw, does anyone knows or is in possesion of the manual where two-digit display of CPU Unit is described?

i have found display desription in that manual:
W465-E1-02 SYSMAC CS and CJ Series - CLICK!
http://support-omron.fr/pdf/W465-E1-02+ ... Manual.pdf
but still not sure about the first issue . . .