[?]: how can reset Omron touch panel NT3S?

CX-One, CX programmer, NTST, Syswin ....
Post Reply
srav
Posts: 1
Joined: Thu Nov 04, 2010 9:08 am

[?]: how can reset Omron touch panel NT3S?

Post by srav » Thu Nov 04, 2010 9:10 am

Hi,
how can reset Omron touch panel NT3S?

thank you

Homeroid_BL
Posts: 259
Joined: Fri Apr 03, 2009 3:24 pm
Location: Bosnia and Herzegovina

Re: [?]: how can reset Omron touch panel NT3S?

Post by Homeroid_BL » Mon Nov 08, 2010 9:29 am

Application erase procedure for NT3S is as follows:
1. At power ON, press the top right corner of the NT3S screen for 2 seconds.
2. Following message is displayed:
“Erase Application?? Press Bottom Right corner to confirm..”
3. Now Press Bottom right corner to confirm Application erase.
4. After application erase is complete following message is displayed:
“No setup loaded. Download Application.”

Firmware erase procedure for NT3S is as follows:
1. At power ON, press the bottom left corner of the NT3S screen for 2 seconds.
2. Following message is displayed:
“Erase Firmware?? Press Bottom Right corner to confirm..”
3. Now Press Bottom right corner to confirm Firmware erase.
4. After firmware erase is complete following message is displayed:
“NT3S-STxxxB-E Boot Version No firmware. Download Firmware..”

If unit stops functioning totally please follow steps given below to recover the unit:
- Erase application.
- Download a demo application. If unit functions properly, maybe the application previously
downloaded was wrong.
- If unit still fails to function properly, erase firmware. Download firmware and application again.

Post Reply