[?]: PinOut for upload program from C200HG?

CX-One, CX programmer, NTST, Syswin ....
Post Reply
Scowl
Posts: 50
Joined: Sun Nov 27, 2005 7:46 pm
Location: Russia

[?]: PinOut for upload program from C200HG?

Post by Scowl » Mon Oct 12, 2009 7:10 am

What I need to upload a program from the SYSMAC C200HG CPU43?
Does CX-ONE3.0 help me to make upload and what cable I need to connect to the CPU?
I found RS232 interface on the front panel of the controller.
Can I use standart RS232 cable for uploading?

most
Posts: 431
Joined: Sat Oct 22, 2005 7:17 am
Location: Europe

Post by most » Mon Oct 12, 2009 9:18 am

PLC - auto online - direct online

cable
PLC(male)...............PC (femal)
1 ............................1
2.............................2
3.............................3
9.............................5
4..5
...............................4..6
...............................7..8

Scowl
Posts: 50
Joined: Sun Nov 27, 2005 7:46 pm
Location: Russia

Post by Scowl » Mon Oct 12, 2009 9:54 am

Thank you very much, most. But I don't understand cable schematic, painted you. Are 4..6 and 7..8 bridges on the PC side and 4..5 on the plc side?

most
Posts: 431
Joined: Sat Oct 22, 2005 7:17 am
Location: Europe

Post by most » Mon Oct 12, 2009 11:27 am

plug PLC
shunt pin 4 and 5

plug PC
shunt pin 4 and 6
and
shunt pin 7 and 8

http://www.megaupload.com/?d=OZMI8UNK
http://www.megaupload.com/?d=E3M19H4E

Post Reply