[?]: Step 7 works on SINUMERIK 840D

liu2002 · Post by **liu2002** » Mon Dec 17, 2007 12:18 am

I'm a new comer and also an graduate.
I've worked for only half a year.
Now i met the question: the machine is based on 840d and i cannot upload the plc program to my pc and i cannot use the step 7 to see the machine's plc backup file.
Step 7 said that you need 840d optional package, what's it?
Maybe the question is silly, but really i don't know.

graucho · Post by **graucho** » Mon Dec 17, 2007 2:15 pm

This optional package is also known as sinumerik hardware for s7.
If you want to upload hardware first install correct version of this package.
After this you can see the sinumerik hardware in s7 project.
What version of the PLC Basic program do you have on this maschine?
(You can check this Diagnostic->service Display->version and on the bootm PLC BP or PLC GP).
When you use operator panel (pcu50) that have connection via btss you should remeber that plc adres is 13 (no 2) from the btss side.

Regards.

liu2002 · Post by **liu2002** » Tue Dec 18, 2007 12:01 am

Thank you. And i read the "About" of the Step 7 Manager inside the machine. An 840D Add-on is installed. So i found one in the forum. Thought it is for S7 v5.3 sp2, i can use v5.4 with it no problem.

pphzh · Post by **pphzh** » Wed Jan 23, 2008 9:37 am

liu2002 wrote:I'm a new comer and also an graduate.
I've worked for only half a year.
Now i met the question: the machine is based on 840d and i cannot upload the plc program to my pc and i cannot use the step 7 to see the machine's plc backup file.
Step 7 said that you need 840d optional package, what's it?
Maybe the question is silly, but really i don't know.

install the 840D toolbox to support 840D hardware

PLCforum.uz.ua

[?]: Step 7 works on SINUMERIK 840D

[?]: Step 7 works on SINUMERIK 840D

Re: [?]: Step 7 works on SINUMERIK 840D