File source

SIMATIC S7-200/300/400, Step7, PCS7, CFC, SFC, PDM, PLCSIM,
SCL, Graph, SPS-VISU S5/S7, IBHsoftec, LOGO ...
Post Reply
Adnan182
Posts: 5
Joined: Mon Aug 01, 2016 5:39 pm

File source

Post by Adnan182 » Tue Aug 09, 2016 10:39 am

When I uploaded the project(in simatic manager V5.5) the symbols and comments weren't shown on my laptop, I need to retrieve or found the file source of the project

Thank you

Schtiel
Site Admin
Posts: 1121
Joined: Wed Sep 06, 2006 12:03 pm
Location: CIS

Post by Schtiel » Tue Aug 09, 2016 11:01 am

From "Programming with STEP 7" manual:

When uploading blocks from the CPU to the programming device, remember that there are two distinct situations:
1. The user program to which the blocks belong is located on the programming device.
2. The user program to which the blocks belong is not on the programming device.
This means that the program sections listed below, that cannot be downloaded to the CPU, are not available. These components are:
  • The symbol table with the symbolic names of the addresses and the comments
  • Network comments of a Ladder Logic or Function Block Diagram program
  • Line comments of a Statement List program
  • User-defined data types

Adnan182
Posts: 5
Joined: Mon Aug 01, 2016 5:39 pm

Re: File source

Post by Adnan182 » Wed Aug 10, 2016 5:31 pm

:) :) :)
Can I retrieve the file source !!???

Thank you very much (pgood) (pgood) (pgood) (pgood) (pgood)

Guille
Posts: 32
Joined: Fri Oct 03, 2008 2:17 am
Location: America

Re: File source

Post by Guille » Fri Aug 12, 2016 2:49 am

Without the source project the answer is NO, you can't

Adnan182
Posts: 5
Joined: Mon Aug 01, 2016 5:39 pm

Re: File source

Post by Adnan182 » Tue Aug 30, 2016 5:55 pm

HI

How i can display accessible nodes ??
there isn't any display when i click on accessile nodes

what' s the problem please !!!??????


THANK YOU VERY MUCH

Post Reply