[?]: unpassword CFC safety program

[maher]

please i have safety program but when i am trying to open the CFC for it the program request from to enter the password but i haven't it .
do you have any program to detect this password for the blocks.

Regards,
Maher

[Schtiel]

Did you try to do this?

[likevc]

I wang to konw too ! It is no useful change CPU Passoword .
If you wang to enter CFC editor ,you must input the Old password.

who can help me ?
best regargs

[maher]

thanks in the first for replying ,
but i don't want to change the password because at practically i can't do it.
i need to detect the the password please.

Best regards,
Maher

[peterg70]

Maher

To be clear about what you are asking please select which option is accurate

Option 1)
I do not have the project and the PLC/Controller is password protected
Option 2)
I have the project and when I open it offline it asks for a password to edit the block/ladder
Option 3)
I have the project and when I connect to the PLC/Controller it asks for a password.

If option 2 need to know software version and also project file to see if password can be found or bypassed.
Option 1 and 3 could be sorted by monitoring the information between PLC/Controller and PC.

[likevc]

when I open CFC programme ,It ask for password for Safety programme

[maher]

I have the project and when I open it offline it asks for a password to read or edit the block/ladde. ( Option 2 )

( If option 2 need to know software version and also project file to see if password can be found or bypassed )
Which software version and project file do you need ?
So what can I do to get the password?

Please tell me.

Regards,

Maher

[likevc]

ok， I upload it.
you must use F system V6.0 and CFC V7.1.2 to open it.
????????????????????

it is in Russia., how can i upload?

[likevc]

I am waiting for your answer.

[maher]

Hello
I am using cfc v7.1+sp2
but i didn't find the source file for the protected cfc

Regards.
Maher

[likevc]

You need to install F System v6.0.
then you can edit the safety programme of CFC ,when you install F system v6,0 ,it would ask for password.

[likevc]

Can you Crack it?

[mario_ing]

Maher

To be clear about what you are asking please select which option is accurate

Option 1)
I do not have the project and the PLC/Controller is password protected
Option 2)
I have the project and when I open it offline it asks for a password to edit the block/ladder
Option 3)
I have the project and when I connect to the PLC/Controller it asks for a password.

If option 2 need to know software version and also project file to see if password can be found or bypassed.
Option 1 and 3 could be sorted by monitoring the information between PLC/Controller and PC.

I have de option 3. How I can to delete this password only for to use the test mode ?

Thanks.

[dileo]

When open function translucent by yellow colour shows message

as crack this password